SMART HOME CLIMATE & HEATING
Set the comfort.
Your home does the rest.
Choose a temperature for each room, or one target for your whole home. Room sensors, radiator valves, floor-heating circuits, your boiler, and compatible air conditioners work together to maintain it automatically.
Design exampleDesigned for your heating and cooling
Your room. Your temperature.
Keep the bedroom cooler and the living room warmer. Every room sensor is compared with its own target, and each radiator or floor-heating valve responds independently.
One setting. Comfort throughout.
Set one whole-home temperature. Cooler rooms keep heating while warmer rooms pause, so the system brings every room toward the same target without giving every valve the same command.
Stop chasing the boiler setting.
Choose the room comfort you want. The controller combines room demands and sends the boiler a supported heating request, so you do not need to keep adjusting the boiler to compensate for a cold or warm room.
Radiators and warm floors, coordinated.
Radiators and floor heating respond at different speeds. Separate valves let the controller adapt each circuit, with floor limits and a suitable water-temperature arrangement for the installation.
The same comfort logic for AC.
Compatible AC units can use the same room sensors and temperature targets. Cooling runs where needed, with mode coordination so heating and cooling do not fight each other in the same room.
Comfort follows your day.
Use a whole-home schedule or room-specific routines. An away profile can reduce demand, then restore your preferred room settings when the schedule or an approved arrival trigger calls for it.
Design demonstration · temperatures and timings are illustrative
We can integrate compatible gas boilers, radiator actuators, floor-heating manifolds, room thermostats, and AC units. Add schedules, window-open rules, guest settings, or phone control around your routine.
A shared target means each room is regulated toward the same temperature, within a configured tolerance. Results depend on insulation, sensor placement, and heating or cooling capacity. Boiler protections, circulation requirements, and equipment operating limits remain active.